http://downloadmirror.intel.com/23573/eng/DN2820FYK_OS_install_v01.pdf
新しいNUC(Bay Trail-M版Celeronベイトレイル)にcentos6.5をインストールしたときのメモ。
これはuefiでのインストールがうまくいかなかったのでLegacy Bootでインストールした。
biosの設定(初期biosは挙動がおかしかったのでまずbiosをアップデート)
上のインテルをテンプレに
1.Press F2 when prompted during boot to enter BIOS Setup.
2.On the Devices and Peripherals > USB menu, set USB3.0 (XHCI mode) support to Enable.
3.On the Devices and Peripherals > SATA menu, set Chipset SATA Mode to AHCI.
4.On the Boot > Boot Priority menu, in the Legacy Boot Priority pane, check Legacy Boot to enable it.
5.On the Boot > Boot Configuration menu, in the UEFI Boot pane, set OS Selection to Windows 7.
6.Press F10 to save your changes and exit BIOS Setup.
7.Proceed with the installation of the operating system.
あとはcd bootで普通にインストール。注意はOS Selectionをwindows7にする。